Pipeng Toolbox : Flow Transient Modules Blank User
Short Cuts
GO
Main ±
Beams ±
References ±
Fluid Flow ±
Fluid Properties ±
Maths ±
Materials ±
Pipelines ±
Soils ±
Subsea ±
Demo

Fluid Flow Transient Modules

Links : ±
CALCULATOR MODULE : Water Hammer Transient Pressure   ±

Calculate water hammer transient pressure and pressure wave velocity.

Water hammer is caused by a sudden reduction of flow rate in liquid pipelines. Water hammer commonly occurs in water pipes, but it can occur in any liquid piping system. The transient pressure is reduced if gas is present in the liquid, or if the effective shut off time is greater than the maximum shut off time. The maximum shut off time is the time taken for the pressure transient to travel to the pipe inlet, and back again.

Change Module :

Related Modules :

CALCULATOR MODULE : Transient Pressure Wave Velocity   ±

Calculate water hammer transient pressure wave velocity.

A sudden reduction of velocity in a liquid pipeline initiates a pressure wave which travels to the pipe inlet, and then back. The wave velocity increases with pipe stiffness. Any gas present in the liquid reduces the pressure wave velocity. The maximum shut off time is the time taken for the pressure transient to travel to the pipe inlet, and back again.

Change Module :

Related Modules :

CALCULATOR MODULE : Water Hammer Pipe Diameter Schedule   ±

Calculate transient flow pipe inside diameter and internal cross section area from pipe diameter and wall thickness.

Use the Result Table option to display a table of the inside diameter and cross section area versus either outside diameter or wall thickness.

Change Module :

Related Modules :

pipeng.com 2025 (534 μs : 6 ms : 0.793 MB) Pengu CMS ©